1999-2001 Porsche 996 911 Carrera 3.4l Engine Long Block / M96/04
Donor Car:
2001 Porsche 996 911 Carrera Cabriolet – 87K
Functionality:
Removed from a running and driving car, fully tested prior to dismantling. Engine started and idled smoothing at 750rpm. Engine revved smoothly with no hesitations or misfires. We have compression tested this engine with good results (Passenger: 170-165-165 / Driver: 160-165-165). We were also able to perform a cylinder leakdown test with <5% leakdown across each cylinder.
We have inspected each cylinder bore with a borescope camera after removal from the vehicle. We did find very minor wear marks in the cylinder wall surfaces if cylinder # 1, 3, and 6. The severity of this wear is not indicative of catastrophic cylinder bore scoring. We have included photos of the cylinder wall condition above.
The engine had very heavy oil residue from the front main seal, valve cover gaskets, and rear main seal. As well as heavier oil leak residue from the factory Air / oil separator and oil cooler, which are common issues on these. We suggest replacing these gaskets, as well as any other easy to access seals while the engine is removed from the vehicle. Oil and coolant have been drained with no abnormalities. Will ship drained of all fluids.
Physical Condition:
In good physical condition, Engine block has not been hit or cracked in any way. Free off any major surface rusting or corrosion. The exhaust manifold studs typically rust and seized due to the extreme heat. We were able to remove all exhaust studs with no damage. You will need to source new exhaust studs for installation. The IMS bearing appears to be the original factory sealed unit as shown.
Includes the engine long block, cylinder heads, oil pan, crank pulley, water pump, alternator, AC compressor, Power steering pump, intake manifold, throttle body, wiring harness, fuel rails, injectors, coil packs, and starter motor as shown. You will need to reuse some of your existing hardware and components for installation.
Fits:
1999, 2000, 2001 Porsche 996 911 Carrera 3.4l (w/ electronic throttle body)
Fitment Notes:
Removed from a 2001 Porsche 996 911 Carrera 2 with the 3.4l engine, tiptronic automatic transmission, and 87k original miles. This engine has the electronic throttle body found on 2000-2001 models equipped with PSM / TC. This can be used for models equipped with the cable throttle control, however you will need to transfer over some of your existing components for use. This engine will physically fit vehicles with the automatic transmissions, however there may be some differences such as wiring and sensors that will need to be swapped over from your old engine. Will NOT fit turbocharged models or vehicles equipped with the X51 package.
Engine Code – M96.04 (interchangeable with M96.01 and M96.02 engine codes)
Reviews
There are no reviews yet.